Scaldapiedi

Info

2 toe warmers
No more cold feet with the Scaldì pads.
Open the package to use the pads, that will reach the optimal temperature in a couple of minutes.
Attach the insoles to the outside of the socks.
Up to 7 hours of heat.

+ Up to 7 hours of heat

+ 100% natural

+ Practical adhesive format

+ Immediate heat

Buy Now

 

Share on Facebook0Tweet about this on TwitterShare on Google+0Pin on Pinterest0Email this to someone

More info

Self-adhesive warming insolses, specifically created to be attached to the outside of socks. The product cannto be used on other parts of the body. Upon opening the pack, due to a process caused by a thermal reaction, the insole will start getting warm in contact with the air, gradually increasing it temperature.

Directions

Once that the package has been opened, wait up to 3/5 minutes manteining the pad in the hand to allow the thermal reaction. Leave the peel and place the adhesive part of the pad directly on the sock, on correspondence of the upper or lower side of the point of the foot. In 30 minutes you will reach the maximum temperature.

Warnings

The product is for external use only. AVOID DIRECT CONTACT WITH BARE SKIN. Do not damage or cut the pad, or remove the powder from the wrapping. Do not swallow. In case of contact with skin or eyes, wash with plenty of cold water and consult a doctor and show this package. If swallowed, immediately consult a doctor. Do not use while sleeping.
Special care should be taken by people with sensitive skin, with disabilities or if suffering of diseases in which heat is contraindicated. Keep out of the reach of children, the elderly or people who are not able to use the product by themselves. In case of too much heat or if itch or even slight redness occur in the treated part, stop immediately the use of product. Avoid use in conditions that could subject the bags to pressure. USE ONLY FOR FEET DO NOT APPLY ON THE FACE.
THIS IS AN ECO FRIENDLY PRODUCT, AFTER THE USE IT COULD BE DISPOSED AS URBAN WASTE.

Ingredients

100% natural raw materials:
 Iron, Vermiculite, Activated Carbon, Potassium Chloride, Water, Sodium Hydroxide